Chip tuning

Chip tuning is a term used to label optimization of power and improvement of torque. All cars, that have been made after year 1990, have for motor control mounted read only memory chip in an automobile's electronic control unit (ECU), also known as the point of ignition, which controls the fuel injection, charge pressure, exhaust, fuel quality, etc.

With optimization of this parameters, we change the program (which ECU uses), so that we significantly improve vehicle acceleration. Doing that, we increase the top speed by 5 - 10 km/h, without changing the service intervals. Possible engine efficiency and torque improvement:

·         - gasoline (petrol) engines up to 10%,

·         - diesel engines up to 20 % and

·         - turbocharged engines between 20 and 40%

Programming is performed by ODB II technology, without swapping the chip or physical intervention in the ECU unit. We are able to perform this type of Chip tuning on almost all automobiles. For some vehicles it is necessary to use special procedure BMD on ECU unit, without prejudice to the EPROM (chip).

We offer unlimited warranty on all optimized programs.

In addition, we also offer a soft off EGR valve, complete software removal DPF filter, fault codes removal from the program (after interference engine computer often detect more errors) and the elimination of problems with the ignition hot car Audi, Seat , Skoda and VW.

The market is flooded with various additional modules to optimize engine power, which modify data on an electronic sensor, but this usually isn’t optimal and it often happens that the ECU starts reporting errors and, therefore, turns on a warning sign, such as: “Check engine”, “service engine” or a yellow sign. Later, sellers of these additives, direct you to car service, although there is a problem in the added module. It’s also not recommended installing cheaper copied optimized programs, because many problems, including poor engine performance or engine damage.

For example: AUDI 1.9 TDI (100 hp) is equipped with the original program that is specific to the exact model of this vehicle. If you copy this module and install it in, say, A3 or A4, which have otherwise identical engine power, problems occur. Each vehicle has its own characteristics, which require their own programs. With offer you develop and upgrade of this programs, thereby avoiding problems. We have all the necessary diagnostic software for program development, and is preferably adapted to the wishes of individual customers (increased engine power, torque, final velocity).

The whole process takes approximately 1 to 2 hours, depending on the type of an engine. By printing results, we perform measurements of power and torque on the rollers, before and after service.

With our processing, your automobile will be powerful and fast at sn affordable price. After all of this, we will be by your side. We offer you service where all the modern technical equipment for the diagnosis of motor and electronics is available, which other chip tuning performers usually do not offer.